Steps
1. Align and place the system chassis under the hinges of the display assembly.
2. Press the left and right hinges in downward direction toward the palmrest assembly.
3. Install the (M2.5x4) and six (M2.5x6) screws to secure the display hinges to the palmrest assembly.
4. Connect the display cable to the connector on the system board and close the latch.
5. Route the display cable through the routing guides in the palmrest assembly.
6. Affix the adhesive tape to secures the display cable in place.
Next steps
1. Install the I/O cable.
2. Install the WWAN card for systems enabled with 4G LTE.
3. Install the WLAN card.
4. Install the base cover.
5. Exit the service mode
6. Install the SIM card tray for 4G LTE enabled systems.
7. Install the microSD-card.
8. Follow the procedure in after working inside your computer.
52
Removing and installing components
To Next Page
Loading...
