14. Remove the display assembly.
15. Remove the system fan.
16. Remove the heatsink assembly.
17. Remove the power adapter port.
18. Remove the I/O board.
19. Remove the coin-cell battery.
20. Remove the USB cable.
21. Remove the WWAN I/O board for systems enabled with 4G LTE.
22. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The following images indicate the location of the palmrest assembly.
Steps
After performing the preceding steps, you are left with the palmrest assembly.
Installing the palmrest assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palmrest assembly.
86
Removing and installing components
To Next Page
Loading...
