3. Remove the SIM card.
4. Remove the microSD card.
5. Remove the base cover.
6. Remove the 2280 solid-state drive or 2230 solid-state drive.
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the battery.
10. Remove the assembly inner frame.
About this task
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
Steps
1. Open the latch and disconnect the smart card reader cable from the connector on the USH board.
2. Remove the three screws (M2x2.5) that secure the smart card reader to the palm-rest assembly.
3. Lift the smart card reader off the palm-rest assembly.
Removing and installing components
59
To Next Page
Loading...
