Dell Latitude 5430 - Palm-Rest Assembly; Removing the Palm-Rest Assembly

About this task
The following images indicate the location of the display back cover and provides a visual representation of the installation
procedure.
Steps
Place the display back cover on a flat surface.
Next steps
1. Install the display hinges.
2. Install the sensor board.
3. Install the eDP cable.
4. Install the camera/microphone module.
5. Install the display panel.
6. Install the display bezel.
7. Install the display assembly.
8. Install the WLAN card.
9. Install the WWAN card.
10. Install the base cover.
11. Install the microSIM card.
12. Install the microSD card.
13. Follow the procedure in after working inside your computer.
Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the microSIM card.
4. Remove the base cover.
Removing and installing components
81