About this task
The figure indicates the location of the HDD and provides a visual representation of the removal procedure.
Steps
1. Locate the HDD on your computer.
2. Disconnect the HDD cable from the system board.
3. Remove the four (M2x2.7) screws that secure the HDD to the system board.
4. Remove the HDD from the computer.
Installing the Hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the HDD and provides a visual representation of the installation procedure.
34
Disassembly and reassembly
To Next Page
Loading...
