Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. Tighten the seven captive screws that secure the heat sink to the system board.
3. Replace the screw (M2x3) that secures the heat sink to the palm-rest assembly.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the microSD card.
4. Install the SIM card.
5. Follow the procedure in After working inside your computer.
Speakers
Removing the speaker
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter service mode.
3. Remove the SIM card.
4. Remove the microSD card.
5. Remove the base cover.
6. Remove the battery.
7. Remove the assembly inner frame.
54
Removing and installing components
To Next Page
Loading...
