Steps
1. Align and place the speakers on the palm-rest assembly.
2. Route the speaker cable through the routing guide on palm-rest assembly.
Next steps
1. Install the assembly inner frame
2. Install the battery.
3. Install the base cover.
4. Install the microSD card.
5. Install the SIM card.
6. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
5. Remove the solid-state drive.
NOTE:
To remove the thermal pad on mylar which is available only in systems with Intel Pyramid Glacier SSD
configuration follow the below steps.
56 Removing and installing components
To Next Page
Loading...
