a. Remove the single screw (M2x4) that secures the M.2 2280 solid-state drive to the system board.
b. Slide and remove the M.2 2280 solid-state drive from the solid-state drive slot on the system board.
c. Peel and remove the thermal pad mylar sticker.
6. Remove the memory module.
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the heat sink.
10. Remove the battery.
11. Remove the system fan.
12. Remove the assembly inner frame.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
Removing and installing components
57
To Next Page
Loading...
