Steps
1. Align and place the keyboard assembly on the palm-rest assembly.
2. Replace the 26 screws (M2x2) that secure the keyboard assembly to the palm-rest assembly.
3. Close the plastic tapes to cover the keyboard assembly screws.
4. Connect the backlight cable and the keyboard cable to the connector on the clickpad.
Next steps
1. Install the system board.
2. Install the assembly inner frame.
3. Install the system fan.
4. Install the battery.
5. Install the heat sink.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the base cover.
9. Install the microSD card.
10. Install the SIM card.
11. Follow the procedure in After working inside your computer.
68
Removing and installing components
To Next Page
Loading...
