Speaker
Removing speaker module
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery
4. To release the speaker module:
a. Push to disconnect the speaker cable from the connector on the system board [1].
NOTE: Ensure to unroute the speaker cable from the routing clip.
NOTE: Use a plastic scribe to release the cable from the connector. Do not pull the cable as it may result in
breakage.
b. Un-route the speaker cable from the routing clips [2].
c. Remove the tape that secures the speaker cables to the touchpad board [3].
5. To remove the speaker module:
a. Remove the M2.0x3.0 screws (4) that secure the speaker module to the computer [1].
b. Lift the speaker module from the computer [2].
NOTE: Ensure to un-route the speaker cable from the routing clips.
Removing and installing components 21
To Next Page
Loading...
