3. Disconnect the battery cable from the connector on the system board.
4. Remove the PCIe SSD card .
5. Remove the SATA SSD.
6. To disconnect the smart card cable:
a. Disconnect the smart card cable [1].
NOTE: Ensure to gently push the connector, to avoid damage to the smart card head.
b. Lift the smart card cable that is affixed to the touchpad module [2].
NOTE: Ensure to pull gently to release it with adhesive tape.
7. To remove the smart card cage:
NOTE: To identify the number of screws, see screw list.
a. Remove the M2 x 3 screws (2) that secure the smart card cage to the computer [1].
b. Slide and lift the smart card cage from the computer [2].
Removing and installing components
31
To Next Page
Loading...
