Key Functions — This field appears below the Option Field
and lists keys and their functions within the active system
setup field.
NOTE: Depending on your computer and installed devices, the items listed in this section may or may not appear.
Lists the computer name, BIOS version, and service tag.
Identifies whether the computer's processor supports Hyper-Threading and identifies the CPU speed, bus speed, clock speed, and L2
cache.
Indicates amount of installed memory, computer memory speed, amount of video memory, size of the display cache, and channel mode
(dual or single).
Displays current date and time settings.
The computer attempts to boot from the sequence of devices specified in this list.
This option enables or disables the floppy drive. The options are Off, Internal, USB, and Read Only.
Identifies and enables and disables the drives attached to the SATA or IDE connectors on the system board and lists the capacities for the
hard drives.
NOTE: These options appear as Drive 0 through Drive 3.
Enables or disables devices in the module bay. The options are On or Off. The default setting is On.
NOTE: The USB Controller and Diskette Drive setup option affect operation of the optional floppy drive in the module bay.
Configures the serial ATA controller's operating mode. Normal enables the serial ATA controller to operate in its serial ATA native mode
only. Compatible enables the serial ATA controller to operate in serial/parallel ATA combination mode.
This setting determines whether hard drive errors are reported or not during system setup.
Configures the operation mode of the integrated hard-drive controller.
Normal — The hard-drive controller is configured for native mode. This mode provides the highest drive performance and most flexibility.
Combination — The hard-drive controller is configured for combination mode. This mode enables compatibility with some older operating
systems that do not support SATA drives.
The factory default setting is Normal.
NOTE: Changing this setting affects the order in which drives are listed. However, system setup does not reflect these changes until after
a reboot.
Controls whether hard drive errors for integrated drives are reported during system status. This technology is part of the SMART (Self-
Monitoring Analysis and Reporting Technology) specification.
The options are On or Off. The default setting is Off.
You can set the NIC to On (default setting), Off, or On w/ PXE. When the On w/ PXE setting is active (available only for the future boot
process), the computer prompts the user to press <Ctrl><Alt><b>. Pressing this key combination causes a menu to display that allows you
to select a method for booting from a network server. If a boot routine is not available from the network server, the system attempts to
boot from the next device in the boot sequence list.
Enables or disables the onboard audio controller
This option sets the operating mode for the built-in parallel port. The settings are Off, AT, PS/2 (default setting), EPP, and ECP.
To Next Page
Loading...
