3. Align the notch on the WLAN card with the tab on the WLAN card slot. Insert the WLAN card into the connector on the
system board.
4. Replace the (M2x3.5) screw to secure the WLAN card bracket to the WLAN card.
Next steps
1. Install the hard-drive assembly.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the fan assembly.
About this task
The following images indicate the location of the heat sink and provide a visual representation of the removal procedure.
Disassembly and reassembly
37
To Next Page
Loading...
