Option Description
mode and type of option ROMs in use. The UEFI Network Stack is required in order
to have UEFI PXE functionality fully enabled.
• Enabled UEFI Network Stack - This option is disabled by default.
Allows you to configure the integrated network controller. The options are:
• Disabled
• Enabled
• Enabled w/PXE: This option is enabled by default.
• Enabled w/Cloud Desktop
NOTE: Depending on the computer and its installed devices, the items listed in
this section may or may not appear.
SATA Operation Allows you to configure the internal SATA hard-drive controller. The options are:
• Disabled
• AHCI - This option is selected by default.
Drives Allows you to configure the SATA drives on board. All drives are enabled by default.
The options are:
• SATA-0
• SATA-1
SMART Reporting This field controls whether hard drive errors for integrated drives are reported
during system startup. This technology is part of the SMART (Self Monitoring
Analysis and Reporting Technology) specification. This option is disabled by default.
• Enable SMART Reporting
USB Configuration This field configures the integrated USB controller. If Boot Support is enabled, the
system is allowed to boot any type of USB Mass Storage Devices (HDD, memory
key, floppy).
If USB port is enabled, device attached to this port is enabled and available for OS.
If USB port is disabled, the OS cannot see any device attached to this port.
The options are:
• Enable USB Boot Support
• Enable Rear USB Ports
• Enable Side USB Ports
All the options are enabled by default.
NOTE: USB keyboard and mouse always work in the BIOS setup irrespective of
these settings.
38
To Next Page
Loading...
