Dell OptiPlex 380 - Communications - Network Adapter (NIC)

DELL™ OPTIPLEX™ 380 TECHNICAL GUIDEBOOK
22
Communications - Network Adapter (NIC)
NOTE: MT supports full height card, DT supports low profile card or full height card with optional riser.
SFF supports low profile card.
Broadcom NetXtreme 10/100/1000 PCIe
Gigabit
1
Networking Card
MT
DT
SFF
Connector Type
RJ-45
Data Rates supported
10/100/1000 Mbps Half/Full duplex
Controller Details
Controller bus architecture (example PCIe 1.0a x1)
PCIe V1.1 x 1
Integrated memory
64KBytes RX, 8KBytes TX
Data transfer mode (example Bus-Master DMA)
Bus-Master DMA
Power consumption (full operation per data rate
connection speed)
2.84W (860mA @ +3.3V)
Power consumption (standby operation)
Less than 300mW
IEEE standards compliance (example 802.1P)
802.3, 802.2, 802.3x, 802.1p
Hardware Certifications (example FCC, B, GS mark…)
FCC B, VCCI B, CE
Boot ROM Support
No
Network Transfer Mode (example Full Duplex, Half Duplex)
Full Duplex/Half Duplex
Network Transfer Rate
10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
Depends on the system environment.
Environmental
Operating temperature
0° C to 55° C (32° F - 131° F)
Operating humidity
5% ~ 85% (non-condensing)
Operating System Driver Support
Windows XP, Windows Vista, Windows 7 (32bit/64bit),
Ubuntu (for China Only)
Manageability (examples WOL, PXE..)
WOL, ACPI
Management Capabilities Alerting (examples ASF 2.0
AMT…)
1
This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet
server and network infrastructure is required.