Installing the power supply unit (PSU)
1. Insert the PSU in the chassis and slide it toward the back of the computer to secure it.
2. Tighten the screws to secure the PSU to the back of the computer.
3. Route the PSU cables through the retention clips.
4. Connect the power cables to the system board.
5. Install the:
a. fan duct
b. optical drive
c. hard drive assembly
d. front bezel
e. cover
6. Follow the procedure in After Working Inside Your Computer.
Removing the VGA daughter board
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
a. cover
b. fan duct
3. To remove the VGA daughter board:
a. Remove the screws that secure the VGA connector to the computer [1].
b. Slide the VGA connector to release it from the computer [2].
c. Remove the screw that secures the VGA daughter board to the computer [3].
d. Lift the VGA daughter board using the handle to remove it from the computer [4].
21
To Next Page
Loading...
