Steps
1. Align and place the antenna modules in the slots on the middle frame.
2. Adhere the copper foil that secures the antenna cables to the middle frame.
3. Replace the two screws (M2x2.5) to secure the antenna modules to the middle frame.
4. Route the antenna cables through the routing guides on the display-assembly base.
Next steps
1. Install the side-I/O board.
2. Install the speakers.
3. Install the rear-I/O bracket.
4. Install the system board.
5. Install the bottom cover.
6. Install the wireless card.
7. Install the hard-drive.
8. Install the system-board shield.
9. Install the back cover.
10. Install the cable cover (optional).
11. Install the stand.
12. Follow the procedure in After working inside your computer.
80
Removing and installing components
To Next Page
Loading...
