2
Removing and installing components
This section provides detailed information on how to remove or install the components from your computer.
Recommended tools
The procedures in this document require the following tools:
• Small at blade screwdriver
• Phillips screwdriver
• Small plastic scribe
Removing the cover
1. Follow the procedure in Before Working Inside Your Computer.
2. To remove the cover:
a. Loosen the captive screw that secures the cover to the computer [1].
b. Slide the cover to release it from the computer [2].
NOTE: You may need a plastic scribe to release the cover from the edges.
c. Lift and remove the cover from the computer [3].
Installing the cover
1. Place the cover on the computer.
2. Slide the cover toward the back of the computer to install it.
3. Tighten the screw to secure the cover to the computer.
4. Follow the procedure in After Working Inside Your Computer.
6
To Next Page
Loading...
