Dell OptiPlex 7050 Micro - Installing the WLAN Card; Pcie SSD; Removing the M.2 Pcie SSD

Installing the WLAN card
Steps
1. Insert the WLAN card into the connector on the system board.
2. Connect the WLAN antenna cables to the connectors on the WLAN card.
3. Place the plastic tab to secure the WLAN cables.
4. Tighten the screw to secure the plastic tab to the WLAN card.
5. Install the:
a. hard drive assembly
b. cover
6. Follow the procedure in After working inside your computer.
M.2 PCIe SSD
Removing the M.2 PCIe SSD
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. 2.5–inch drive assembly
3. To remove the M.2 PCIe SSD:
a. Remove the screw that secures the M.2 PCIe SSD [1].
b. Lift and pull out the PCIe SSD from its connector [2].
16
Disassembly and reassembly