4. Close the processor shield by sliding it under the retention screw.
5. Lower the socket lever and push it under the tab to lock it.
6. Install the:
a. heat sink
b. system fan
c. 2.5–inch drive assembly
d. cover
7. Follow the procedure in After working inside your computer.
System board
Removing system board
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. 2.5–inch drive assembly
c. system fan
d. heat sink
e. processor
3. To remove the plastic tab:
a. Remove the screw that secures the plastic tab to the system board [1].
b. Lift the plastic tab away from the system board [2].
24
Disassembly and reassembly
To Next Page
Loading...
