WARNING: Dell's Disk Monitoring System has detected that drive [0/1] on the
[primary/secondary] EIDE controller is operating outside of normal
specifications. It is advisable to immediately back up your data and replace your
hard drive by calling your support desk or Dell— During initial start-up, the drive
detected possible error conditions.
● When your computer finishes booting, immediately back up your data and replace
your hard drive (for installation procedures, see "Adding and Removing Parts" for
your computer type).
● If no replacement drive is immediately available and the drive is not the only
bootable drive, enter system setup and change the appropriate drive setting to
None. Then remove the drive from the computer.
Write fault— The operating system cannot write to the floppy or hard drive. See "
Drive
Problems" for troubleshooting suggestions.
Write fault on selected drive— The operating system cannot write to the floppy or hard
drive. See "
Drive Problems" for troubleshooting suggestions.
x:\ is not accessible. The device is not ready— The floppy drive cannot read the disk.
Insert a floppy disk into the drive and try again.
General Problems
A program stops responding
End the program
Windows XP, Windows 2000
1. Press <Ctrl><Shift><Esc> simultaneously.
2. Click Applications.
3. Click the program that is no longer responding.
4. Click End Task.
Windows NT®
1. Press <Ctrl><Alt><Delete> simultaneously.
2. Click Task Manager, and click Applications.
3. Click the program that is no longer responding.
4. Click End Task.
Windows 98
http://support.dell.com/support/edocs/systems/opgx260/en/ug/solvprob.htm (16 of 30) [10/25/2007 1:44:24 PM]
To Next Page
Loading...
