9. Replace the two screws (M1.6x3.5) that secure the camera and display-assembly cable to the display-assembly interposer
board on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
I/O daughter-board
Removing the I/O daughter-board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the fan.
About this task
The following image(s) indicate the location of the system board and provides a visual representation of the removal procedure.
28
Removing and installing components
To Next Page
Loading...
