Setting up the monitor │ 49
Setting up the monitor
Attaching the stand
NOTE: The stand assembly is not pre-installed when the monitor is
shipped from the factory.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the setup instructions that
were included with the stand.
To attach the monitor stand:
1. R
emove the stand riser and stand base from the packaging cushion.
NOTE: The images are for the purpose of illustration only. The
placement and appearance of the package cushion may vary by model.
2. Inse
rt the stand base blocks fully into the stand slot.
3. L
ift the screw handle and turn the screw clockwise.
To Next Page
Loading...
