Dell PowerConnect 3548 User Manual

Configuring System Information 131
Defining a Device’s IPv4 Gateway Using the CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the Default
Gateway page
.
The following is an example of the CLI commands:
Defining IPv4 Interfaces
The IPv4 Interface Parameters page contains fields for assigning IP parameter to interfaces.
To open the IP Interface Parameters page, click System
→ IP Addressing→ IPv4 Interface Parameters in
the tree view.
Figure 6-27. IPv4 Interface Parameters
Table 6-19. Default Gateway CLI Commands
CLI Command Description
ip default-gateway ip-address Defines a default gateway.
no ip default-gateway Removes a default gateway.
console(config)# ip default-gateway 196.210.10.1
console(config)# no ip default-gateway

Dell PowerConnect 3548 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	0.1 Gbit/s
Supported data transfer rates	10/100 Mbps
10G support	-
Number of VLANs	256
Flow control support	Yes
Networking standards	IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3ad
Dimensions (WxDxH)	440 x 257 x 43.2 mm
Networking features	Gigabit Ethernet, Fast Ethernet
Authentication method	RADIUS, TACACS+
Connectivity technology	Wired
Switch type	Managed
Switch layer	L2
Data link protocols	Ethernet
Supported network protocols	HTTP, HTTPS/SSL, SSH
Power connector	DC-in jack
SFP/SFP+ slots quantity	2
Basic switching RJ-45 Ethernet ports quantity	48
Product color	Black
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	8000 g