Need help?Do you have a question about the Dell PowerConnect 3324 and is the answer not in the manual?
General| Switching Capacity | 12.8 Gbps |
|---|---|
| Layer | Layer 2 |
| MAC Address Table Size | 8K |
| RAM | 64 MB |
| Flash Memory | 16 MB |
| Management | Web-based, CLI, SNMP |
| Operating Humidity | 10% to 90% non-condensing |
| Power Supply | Internal, 100-240V AC |
| Dimensions (W x D x H) | 440 x 250 x 44 mm |
| VLAN Support | Yes, 256 VLANs |
| Quality of Service (QoS) | 4 Queues per port |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Jumbo Frame Support | Yes, up to 9000 bytes |
Provides details about the PowerConnect 3324 and 3348 Layer 2 switches.
Explains the stacking architecture and capabilities of PowerConnect 3324/3348 switches.
Details dimensions, rear panel layout, and hardware components of the device.
Lists critical safety and handling precautions for installation.
Specifies environmental and physical requirements for device installation.
Provides steps for unpacking the device and installing it in a rack or on a surface.
Details cable connections, port descriptions, and pinout allocations for interfaces.
Guides through setting static IP, subnet mask, default gateway, and user credentials.
Covers dynamic IP addressing (DHCP/BOOTP) and security management.
Provides instructions on setting up multiple units as a single system.
Covers assigning interface IP, default gateway, ARP, and DHCP parameters.
Details security configurations like access profiles, authentication, and user databases.
Details setting network security using Access Control Lists and Locked Ports.
Explains STP operation, global settings, port settings, and LAG settings.
Details VLAN creation, membership, port settings, and LAG configurations.
Sets global QoS parameters including trust mode and scheduling schemes.
To Next Page