Dell PowerConnect 3324 - Defining STP LAG Settings

248 Configuring Switch Information
www.dell.com | support.dell.com
Console(config-if)# spanning-tree cost 35000
Console(config-if)# spanning-tree port-priority 96
Console(config-if)# exit
Console(config)# exit
Console# show spanning-tree ethernet 1/e5
Console# show spanning-tree ethernet 1/e5
Interface Port IDDesignated Port ID
Name PrioStsEnb CostCost Bridge ID Prio.Nbr
----- ------- --- ---------------------- --------
1/e5128DSBLTrue1000 8000 xx.xx.xx.xx.xx.xx80 001
Spanning tree enabled
Port Fast: no (configured: no)
Type: point-to-point (configured: auto)
Number of transitions to forwarding state: 1
BPDU: sent 2, received 120638
Defining STP LAG Settings
The STP LAG Settings page allows network managers to assign STP parameters for LAGs.
To open the STP LAG Settings page:
• Click Switch > Spanning Tree > LAG Settings in the Tree View. The STP LAG
Settings page opens.