136 Configuring System Information
www.dell.com | support.dell.com
The following is an example of the CLI commands:
Console (config)# interface ethernet 1/e8
Console (config-if)# ip address-dhcp hostname marketing
Configuring ARP
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses
into physical addresses. The static entries can be defined in the ARP Table. When static
entries are defined, a permanent entry is entered and is used to translate IP address to MAC
addresses. To open the ARP Settings page:
• Click System > IP Addressing > ARP in the Tree View. The ARP Settings page
opens.
ARP Settings Page
CLI Command Description
ip address-dhcp [hostname
host-name]
Acquires an IP address on an ethernet
interface from DHCP.
To Next Page
Loading...
