Configuring System Information 183
3 Click Apply Changes. The Image file is selected. The Image file reloads only after the
next reset. The currently selected Image file continue to run until the next device
reset. For instruction on resetting the device, see "Resetting the Device".
Working with the Active Image File Using CLI Commands
The following table summarizes the equivalent CLI commands for viewing fields displayed
in the Active Images page.
The following is an example of the CLI commands:
Console# boot system image-1
Copying and Deleting Files
Files can be copied and deleted from the Copy Files page. To open the Copy Files page:
•Click System > File Management > Copy Files in the Tree View. The Copy Files
page opens.
CLI Command Description
boot system [unit | unit
] {image-1 | image-2}
Specifies the system image that the device loads at
startup.
To Next Page
Loading...
