Need help?Do you have a question about the Dell PowerConnect 2808 and is the answer not in the manual?
General| Switching Capacity | 16 Gbps |
|---|---|
| Forwarding Rate | 11.9 Mpps |
| Layer | Layer 2 |
| MAC Address Table | 8K |
| Jumbo Frame Support | 9KB |
| Power Supply | Internal |
| Ports | 8 x 10/100/1000BASE-T |
Explains the meaning of NOTE, NOTICE, and CAUTION messages.
Describes the hardware configurations of the PowerConnect 28xx series switches.
Details general, Layer 2, VLAN, STP, CoS, and management features of the switches.
Describes front/back panel ports, physical dimensions, LEDs, cables, and default port settings.
Details physical dimensions, LEDs (Power, Managed Mode, Fan, Port), buttons, and fans.
Explains cable requirements, RJ-45 pinouts, and SFP port details.
Outlines default settings for port speed, duplex, flow control, and MDI/MDIX.
Covers safety precautions, grounding, ventilation, and environmental requirements.
Provides steps for unpacking, mounting, and connecting the device to network and power.
Explains Managed, Unmanaged, Secure modes and how to transition between them.
Details initial configuration via Set-up Wizard, Web interface, and startup menu.
Defines system details, IP addressing, and security settings like Secure Mode.
Explains how to run cable diagnostics and reset the device.
Covers network security, port parameters, Green Ethernet, Storm Control, and Port Mirroring.
Details Spanning Tree, VLANs, Link Aggregation, and Multicast forwarding.
Details RMON statistics, charts, and CPU utilization monitoring.
Covers CoS/QoS settings, interface settings, and queue mapping.
Covers CLI access methods, command modes, and common commands.
To Next Page
