162 Dell PowerConnect 28xx Systems User Guide
Syntax Description
•
vlan-id
— VLAN ID
Parameters range
•
vlan-id
— Valid VLAN
Command Modes
Global Configuration
Usage Guidelines
In case the VLAN doesn't exist ("ghost VLAN") only partial list of the commands would be available
under the interface VLAN context.
The commands that are supported for VLAN that doesn't exist are:
1
IGMP snooping control
2
Bridge multicast configuration
Example
In the following example, for VLAN 1, the address is 131.108.1.27 and the subnet mask is 255.255.255.0:
Console (config)# interface vlan 1
Console (config-if)# ip address 131.108.1.27 255.255.255.0
Command: ip address
Use the ip address Interface Configuration mode command to define an IP address for an interface. Use
the no form of this command to remove an IP address definition.
ip address
ip-address
{
mask
|
/prefix-length
} [default-gateway
ip-address
]
no ip address
Syntax Description
•
ip-address
—Specifies the IP address.
•
mask
—Specifies the network mask of the IP address.
•
prefix-length
—Specifies the number of bits that comprise the IP address prefix. The prefix length
must be preceded by a forward slash (/).
•
default-gateway
ip-address
—Specifies the default gateway IP address.
Parameters range
•
ip-address
— Valid IP address
•
mask
—Valid mask
To Next Page
Loading...
