EasyManua.ls Logo

Dell POWERCONNECT 6200 SERIES - Page 159

Dell POWERCONNECT 6200 SERIES
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Multicast 159
console#show ip igmp
IGMP Admin Mode................................ Enabled
IGMP Router-Alert check........................ Disabled
IGMP INTERFACE STATUS
Interface Interface-Mode Operational-Status
--------- -------------- ----------------
vlan 100 Enabled Operational
vlan 200 Enabled Operational
The host connected to interface 1/g5 sends an IGMP join message for multicast group 225.1.1.1 in
VLAN 100. Then, the host connected to 1/g15 sends multicast data for group 225.1.1.1 in VLAN 200.
Interface 1/g5 sends and receives the multicast data from the host on interface 1/g15. The multicast
traffic must be routed because the hosts on 1/g5 and 1/g15 are in different subnets. Due to IGMP
snooping, interface 1/g10 does not send or receive any multicast data even though it is in the same
broadcast domain as interface 1/g5.
console#show bridge multicast address-table
Vlan MAC Address Type Ports
---- ----------------------- ------- ------------------
100 0100.5E01.0101 Dynamic 1/g5
Forbidden ports for multicast addresses:
Vlan MAC Address Ports
---- ----------------------- ----------------------------
100 0100.5E01.0101
console#show ip mcast mroute summary
Multicast Route Table Summary
Incoming Outgoing
Source IP Group IP Protocol Interface Interface List
--------------- --------------- --------- --------- ---------------
20.20.20.20 225.1.1.1 PIMDM vlan 200 vlan 100

Table of Contents

Other manuals for Dell POWERCONNECT 6200 SERIES

Related product manuals