Dell POWERCONNECT 6200 SERIES - Page 41

Switching Configuration 41
1. Create VLAN 100.
console#configure
console(config)#vlan database
console(config-vlan)#vlan 100
2.
Enable IGMP snooping on the VLAN.
console(config-vlan)#ip igmp snooping 100
console(config-vlan)#exit
3.
Forbid the forwarding of unregistered multicast addresses on VLAN 100 to prevent multicast flooding
to ports if there are no "listeners."
console(config)#interface vlan 100
console(config-if-vlan100)#bridge multicast forbidden
forward-unregistered
console(config-if-vlan100)#exit
4.
Globally enable IGMP on the switch.
console(config)#ip igmp snooping
5.
Configure port 1/g5 as a member of VLAN 100.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#switchport access vlan 100
console(config-if-1/g5)#exit
6.
Configure port 1/g10 as a member of VLAN 100.
console(config)#interface ethernet 1/g10
console(config-if-1/g10)#switchport access vlan 100
console(config-if-1/g10)#exit
7.
Configure port 1/g15 as a member of VLAN 100.
console(config)#interface ethernet 1/g15
console(config-if-1/g15)#switchport access vlan 100
console(config-if-1/g15)#exit
8.
Configure port 1/g20 as a member of VLAN 100.
console(config)#interface ethernet 1/g20
console(config-if-1/g20)#switchport access vlan 100
console(config-if-1/g20)#exit