106 Installing Drives
www.dell.com | support.dell.com
Figure 7-8. Removing and Installing a SATA Hard Drive
7
Install the hard-drive cage:
a
With the side of the drive cage labeled "Top" facing toward the external drive bays, slide
the drive cage into the system. See Figure 7-8.
b
Replace the four screws that secure the drive cage in the system.
8
Connect all power cables and interface cables to the hard drives remaining in the drive bays.
9
If your system is configured as a tower, stand the system upright.
drive-cage retention
screws (4)
hard-drive bay
drive-bay retention screws
(2 screws on each side of drive cage)
power cable
interface cable
To Next Page
Loading...
