Installing Drives 99
Figure 7-3. Installing a 5.25-Inch Drive
8
Connect a DC power cable connector to the drive's power input connector. See Figure 7-3.
9
If you are connecting the drive to a controller card, proceed to step 10. If you are connecting
the interface cable to a system board connector:
a
Remove the baffle/back fan assembly. See "Removing the Baffle/Back Fan Assembly."
b
Press and hold the expansion-card guide release tab and remove the expansion-card
guide.
See Figure 6-1.
c
Remove the four drive bay screws and slide the drive bay forward to access the drive-cable
retainer.
5.25-inch drive
externally accessible drive bay
power cable
interface cable
screws (2)
To Next Page
Loading...
