Dell PowerEdge 2800 - Installing the Slide Assemblies for Flush-Mount Configuration

Rack Installation Guide 1-29
Figure 1-18. Installing the Slide Assemblies for Flush-Mount Configuration
10
Use an 11/32-inch wrench or nut driver to fully tighten the nuts on the mounting brackets
on both slide assemblies that you tightened with your fingers.
11 Install the stiffening bracket between the back ends of the slide assemblies and secure
the bracket with a 12-24 0.5-inch pan-head Phillips screw on each slide assembly
(see Figure 1-18).
system locking mechanism
slide assembly
12-24 x 0.5-inch pan-head Phillips
screw (8 per slide assembly)
stiffening bracket