Dell POWEREDGE 4300 - Page 139

Installing System Board Options 8-15
)LJXUH5HPRYLQJDQ6(&&DUWULGJHDQG+HDW6LQN$VVHPEO\
5HSODFLQJWKH6(&&DUWULGJHDQG+HDW6LQN$VVHPEO\
Use the following procedure to install the replacement SEC cartridge and heat sink
assembly:
1. Remove the terminator card or old SEC cartridge from the guide bracket
assembly.
Follow the instructions in “Removing a Terminator Card” or “Removing the SEC
Cartridge and Heat Sink Assembly” found earlier in this chapter, as appropriate.
2. With the heat sink facing the other microprocessor socket, slide the SEC car-
tridge into the guide bracket assembly and firmly seat the assembly (see
Figure 8-11).
3. Reinstall the two retention pins to secure the SEC cartridge and heat sink
assembly.
4. Verify that the cartridge release latches on the guide bracket assembly are pulled
out.
SEC cartridge
release latches (2)
heat sink
SEC cartridge
retention pins (2)
guide bracket
assembly