134 Installing System Components
Installing the Control Panel Board Assembly and the Control Panel
Display Module
For LED control panel, proceed to step 3. Insert the display module into the
chassis cutout and secure with the two screws.
1
Affix the replacement panel to the front of the display module.
2
Align the slot in the control panel board with the standoff on the system
chassis and secure with the two screws. See Figure 3-24. For LED control
panel, skip step 4.
3
Connect the display module cable to the control panel board.
4
Connect the USB and control panel cables to the control panel board.
5
Close the system. See "Closing the System" on page 79.
6
If applicable, replace the optional front bezel. See "Front Bezel (Optional)"
on page 77.
7
Reconnect the system to the power source and turn on the system and
attached peripherals.
R310HOM.book Page 134 Thursday, March 4, 2010 1:03 AM
To Next Page
Loading...
