20 About Your System
8 Active ID CMA
connector
Connector for attaching a system
indicator extension cable that is used
on a cable management arm.
9 System status indicator Lights blue during normal
system operation.
Both the systems management software
and the identification buttons located
on the front and back of the system can
cause the indicator to flash blue to
identify a particular system.
Lights amber when the system needs
attention due to a problem.
10 System identification
button
Turns the system ID modes on and off.
The identification buttons on the front
and back panels can be used to locate a
particular system within a rack. When
one of these buttons is pushed, the
LCD panel on the front and the system
status indicator on the chassis back
panel light blue until one of the
buttons is pushed again.
11 Power supply 1 (PS1) 400 W (redundant power supply).
12 Power supply 2 (PS2) 400 W (redundant power supply).
Item Indicator, Button, or
Connector
Icon Description
R310HOM.book Page 20 Thursday, March 4, 2010 1:03 AM
To Next Page
Loading...
