Dell PowerEdge E31S Series - Installing a 1.8-Inch Hard Drive Blank

Figure 94. Removing a 1.8-inch hard drive blank
a. hard drive blank
b. release button
Next steps
If applicable, install the front bezel.
Related references
Safety instructions on page 66
Related tasks
Removing the optional front bezel on page 68
Installing the optional front bezel on page 69
Installing a 1.8-inch hard drive blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. If installed, remove the front bezel.
Steps
Insert the hard drive blank into the hard drive slot until the release button clicks into place.
Next steps
If applicable, install the front bezel.
Installing and removing system components
157