Dell PowerEdge E31S Series - Installing the Optional Front Bezel

Figure 15. Removing the optional Quick Sync front bezel
a. release latch
b. bezel lock
c. Quick Sync bezel
Installing the optional front bezel
Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Locate and remove the bezel key.
NOTE: The bezel key is attached to the back of the bezel.
2. Hook the right end of the bezel onto the chassis.
3. Fit the free end of the bezel onto the system.
4. Lock the bezel by using the key.
Installing and removing system components
69