Figure 29. Removing a heat sink
1. retention screw (4) 2. heat sink
3. processor shield 4. retention screw slot (4)
Figure 30. Removing a 165 W heat sink
1.
heat sink 2. retention screw (4)
3. processor socket 4. retention screw slot (4)
Next steps
1. Replace the heat sink(s) and processor(s).
2. Replace the processor and heat sink.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 66
Related tasks
Before working inside your system on page 67
Installing and removing system components
89
To Next Page
Loading...
