54 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
8.1.2 Configuring VLT on the FN IOM
In this section, the VLTi peer link is configured (Figure 39).
First, the port channel that will be assigned as the VLTi peer link is created. Next, in PMUX mode, a
VLT domain is created. The peer link is then assigned and the backup destination is configured to
enable the heartbeats to go over the management network. Finally, a unit ID is specified to ensure that
the two IOM peer switches are assigned primary or secondary roles.
Note: In this example, the port channel number matches on both sides. This is not a strict
requirement.
VLT Domain VLT Domain 2
VLTi (Po 127)
FC630 Server
Te 0/9 Te 0/10
FN410S-A1
FN410S-A2
S4810-1
Te 0/10Te 0/9
S4810-2
VLTi peer link configuration
To Next Page
Loading...
