Dell PowerEdge FX2 - FN IOM Internal Port Mapping - Detailed Overview

18 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
The Dell Blade I/O Manager Dashboard page allows an overall configuration view of the FN IOM,
which includes:
 FN IOM Mode
 Management IP address
 Recently logged activity
 Bandwidth utilization
 Detailed Port view
 Detailed mode view (Standalone, VLT, Stacked, Programmable Mux, Full Switch)
The menu choices on the left include logging information, Port configuration (both internal and
external), Switching, Security, and Settings. As can be seen from this brief overview, the FN IOM Dell
Blade I/O Manager can provide much of the functionality that is typically relegated to the CLI.
5.2 FN IOM internal port mapping -- detailed overview
Quarter-height slots - dual-port CNAs
In quarter-height slots configured with dual-port CNAs, the servers map to a single port on each of the
two IOAs.
The naming convention for quarter-height slots are different from the naming conventions for the half-
height and full-height slots. As shown in Figure 1514, the first row of the quarter-height slots are
designated 1a through 1d, and the second row 3a through 3d. Figure 15 and Table 2 present the port
mapping for quarter-height slots with dual-port CNAs.
Note: Quad-port CNAs are not available for quarter-height servers.