Dell PowerEdge FX2 - Page 89

89 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
Further information about the vPC peer switch keepalive can be extracted using show vpc peer-
keepalive. The current status, IP address and the VRF associated with the keepalive are shown in
the following output.
Nx5672-1
5548-1# show vpc peer-keepalive
vPC keep-alive status : peer is alive
--Peer is alive for : (1048732) seconds, (737) msec
--Send status : Success
--Last send at : 2014.05.13 11:35:04 592 ms
--Sent on interface : mgmt0
--Receive status : Success
--Last receive at : 2014.05.13 11:35:04 477 ms
--Received on interface : mgmt0
--Last update from peer : (0) seconds, (215) msec
vPC Keep-alive parameters
--Destination : 172.25.109.24
--Keepalive interval : 1000 msec
--Keepalive timeout : 5 seconds
--Keepalive hold timeout : 3 seconds
--Keepalive vrf : management
--Keepalive udp port : 3200
--Keepalive tos : 192