Dell PowerEdge FX2 - 11 Configuring User Accounts and Privileges; User Types and Privileges

97 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
Confirm restore
When the FN IOM Dell Blade I/O Manager is restarted after the factory reset process, an Initial Setup
Wizard (Figure 65) automatically launches. This wizard allows a network administrator to set
fundamental parameters such as new User Name and Password credentials other than the default
root/calvin, as well as Management IP Address, Network Time Protocol, etc.
FN IOM Initial Setup Wizard
Note: The Initial Setup Wizard can be invoked at any time from the Dell Blade I/O Manager
Dashboard view. The Initial Setup link under Quick Tasks on the right side of the page can restart the
setup process if needed.