272 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
dot1x quiet-period
17
dot1x quiet-period
Sets the number of seconds that a switch remains quiet between a failed authentication and an
attempt to retry authentication.
Synopsis dot1x quiet-period interval seconds
no dot1x quiet-period
Operands interval seconds Specifies the time in seconds between attempts at authentication. The range
of valid values is 1-65535.
Defaults The default time is 60 seconds.
Command
Modes
Interface configuration mode
Description Use this command to set the time in seconds after which a switch attempts to perform
authentication after a failed authentication. Use the no dot1x quiet-period command to return to
the default setting. When a switch cannot authenticate a client, the switch remains idle for a
quiet-period interval of time, then attempts the operation again.
Usage
Guidelines
Changing the quiet-period interval time to a number lower than the default can result in a faster
response time.
Examples To change the interval time to 200 seconds:
switch(config)#interface extengigabiethernet 0/16
switch(conf-if-te-0/16)#dot1x quiet-period 200
See Also none
To Next Page
Loading...
Need help?
General