Need help?Do you have a question about the Dell EMC PowerEdge M640 and is the answer not in the manual?
General| Product Type | Server |
|---|---|
| Maximum Processors | 2 |
| Management | iDRAC9 with Lifecycle Controller |
| Form Factor | Blade |
| Processor | Intel Xeon Scalable processors |
| Memory | Up to 3 TB |
| Network Interfaces | 2 x 10GbE ports |
| Operating System Support | Windows Server, Linux, VMware |
| Chassis | PowerEdge M1000e or VRTX |
| RAID Support | PERC RAID controllers |
Describes the front panel components and status indicators of the server.
Explains the location and content of the system information label.
Step-by-step guide for initial system setup and installation into the enclosure.
Details on configuring the Integrated Dell Remote Access Controller for system management.
Methods for downloading and installing system firmware and drivers.
Essential safety instructions and prerequisites before performing component servicing.
Procedures for removing the server from its enclosure and installing it back.
Guidelines and steps for installing and removing system memory modules (DIMMs).
Procedures for removing and installing processors and their associated heat sink modules.
Steps for removing and installing the main system board.
Information on upgrading, removing, and initializing the Trusted Platform Module.
Identifies system board connectors and jumpers with their functions.
Instructions for disabling forgotten system or setup passwords using a jumper.
Guide to running the Enhanced Pre-boot System Assessment diagnostics tool.
Explanation of controls and information available within the system diagnostics utility.
Information on how to contact Dell EMC for technical assistance and sales support.
Guidance on finding and viewing relevant documentation and online resources.
To Next Page