Dell EMC PowerEdge M640 - Installing the M.2 SSD Module

Steps
1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
2. Pull the M.2 SSD module away from the BOSS card.
Figure 37. Removing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. module (2)
Next steps
Install the SSD card.
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the M.2 SSD module connectors with the connectors on the BOSS card.
2. Push the M.2 SSD module until the module is seated firmly on the BOSS card.
3. Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
Installing and removing system components
45