Dell EMC PowerEdge M640 - Storage Controller Card; Removing the Storage Controller Card

Figure 42. Installing the PCIe mezzanine card
Next steps
Follow the procedure listed in After working inside your system.
Storage controller card
Removing the storage controller card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the following:
a. Drives
b. Drive backplane
c. Drive cage
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screws on the drive cable connector and lift it away from the storage
controller card.
CAUTION: To prevent damage to the storage controller card, you must hold the card only by its edges.
2. Lift the storage controller card away from the system.
50
Installing and removing system components