Figure 38. Installing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. modules (2)
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the mezzanine card.
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system
board.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
46
Installing and removing system components
To Next Page
Loading...
